Margin issues

About the programming interface for the virtual PDF printer driver.

Moderator: jr

Post Reply
Erikf
Posts: 2
Joined: Thu Nov 29, 2007 7:40 pm
Location: NY

Margin issues

Post by Erikf »

I've been testing Bullzip for a couple of days and have everything working perfectly, with one exception - Margins. The PDF's produced look great, they're just too close to the left side. Is there anything I can do to adjust that? If not, do you have any plans to address that at some point in the future?

Other than that one last sticky spot, it's great! Kudos!

Erik
jr
Site Admin
Posts: 500
Joined: Sun Mar 26, 2006 12:28 pm

Post by jr »

You can change the printing margin in most programs by using the "Page Setup" dialog or something similar. By default the PDF printer supports printing to the edge of the PDF document.

Regards,
Jacob
Erikf
Posts: 2
Joined: Thu Nov 29, 2007 7:40 pm
Location: NY

Unattended?

Post by Erikf »

Jacob,

I'm trying to do this without user intervention of any kind. Our users select anywhere from one to six documents which are generated to the same PDF file and e-mailed directly through our application.

I've got one or two other things that I may be able to try but I was hoping for an easier solution. Now for the hard way ...

Thanks!

Erik
grivero
Posts: 1
Joined: Wed Dec 19, 2007 7:18 am

Printer Margins

Post by grivero »

Hi Erikf.

Did you find a way to change the printer margins ?

Thanks
Post Reply